Sealey Power Hoist 400kg Capacity 230V PH400

Sealey Power Hoist 400kg Capacity 230V PH400Approved to EU and UK Lifting Gear Regulations. This hoist is intended for use where a suitable support facility exists. Support brackets are included with the equipment. The support bar is not included. Approved to EU and UK Lifting Gear Regulations. This hoist is intended for use where a suitable support facility exists. Support brackets are included with the equipment. The support bar is not included.

Single lithium battery will run approximately 4000 test cycles

Burst Pressure: 100 Bar

Wheel Size: 12 inch

sheet metals

8PC SET Sizes: 2

SECURITY - Brass cylinder with twin bar locking mechanism

adjustable flow control feature and snap on connector

micro-touch valve for instant shut-off when tank is full

Integral 13mm drill chuck is easily accessible from both sides of the head

Manufactured from heat treated and hardened S2 steel with a fully polished satin finish

Forward and reverse at the flick of a lever

Supplied with thrust shaft extension and storage case